Aircon cooling only on driver side, LHD car

Prototypen

Member
Last year I changed the high-pressure sender G65 and temperature sender G263, after that the aircon was working perfect.
Now when the heat returns ( I live in Portugal and we now have 27-30 degrees C).
I have checked the fault codes and have two which basically are the same problem.
Engine
18043 - Powertrain Data Bus
P1635 - 35-10 - Missing Message from A/C Controller - Intermittent
Instruments
Readiness: 0010 0101
01320 - Control Module for Climatronic (J255)
49-10 - No Communications - Intermittent

When it´s 25 deg outside I have approx 15 deg in the centre air outlet, 2 deg on driver side outlet (LHD car) and basically outside temp on passenger side.
Temp measured with laser thermometer.
How can it be very cold air on driver side and nothing on passenger side? Can it be some flaps inside the air-ducts that not working?
Any idea where to start? Yes I will check all connectors at centre console control and control module for climatronic.
But I don't believe that is the problem for the non cooling on the passenger side?
 
You're 100% sure the vent is actually open? Taking the glove box out may help to understand but not much. I don't remember if the V68 temperature flap is split. But your errors imply that it's "working correctly", I suspect that the flap itself has come ´loose on one side, which is going to be a pig of a job to fix.

- Bret
 
Any one have a illustration on the air-duct system for a LHD car? Just as a help to find position and function for the different flaps. Was checking the temps one more time today.
Lefthand side (driver side) - 3,9 C
Middle 3,2 C
Righthand side (Passenger) 13,9 C
 

Attachments

  • AC 1  20190430_105232.jpg
    AC 1 20190430_105232.jpg
    970.2 KB · Views: 205
  • AC 2 20190430_105259.jpg
    AC 2 20190430_105259.jpg
    1 MB · Views: 179
  • Ac 3 20190430_105320.jpg
    Ac 3 20190430_105320.jpg
    612.5 KB · Views: 217
Perhaps this manual page may show what you need.
and this.

 
Thanks "audifan", today it was warm inside the car when I was going for shopping! Yes it's C not F!
 

Attachments

  • 20190501_120.jpg
    20190501_120.jpg
    549.8 KB · Views: 168
Finally I got to check the fault codes:

01273 - Fresh Air Blower (V2)
17-10 - Control Difference - Intermittent
As there are two inside temperature senors one left and one right I have a feeling that the right one is out of order? It can also be a bad connection but I will order a new sensor for to change it. I had one of them out when I changed the G263? sensor last year.
 

Attachments

  • 2018-06-07 16.39.35.jpg
    2018-06-07 16.39.35.jpg
    1 MB · Views: 274
There is a LHD schematic available which may help if further investigation is required

Cheers Spike
 
Back
Top