BHC / ATL engine with Bosch tandem pump adaptor

No surprise there then. Perhaps contact some of the other breakers on ebay with a request? Or our own although pretty rare. Does not look like it was fitted to other models either.
 
I suspect you are correct, but I would only be buying it for stock, so would rather leave it available for someone who needs the part modifying.
I suspect you are correct in that it was only fitted to the 1.4 tdi and not the 1.9
Paul
 
I do remember buying mine off eBay.It was still attached to the egr,the best part was the egr was in good condition so I swapped that too.The listing was indeed for a polo.Maybe even Skoda's have them?
 
I do remember buying mine off eBay.It was still attached to the egr,the best part was the egr was in good condition so I swapped that too.The listing was indeed for a polo.Maybe even Skoda's have them?
this is what i've done too, £24 for the egr, manifold and extension piece. so searching for tdi90 or atl egr might be the way to go. cheers
 
  • Like
Reactions: fhl
see earlier post, £30 + £3 postage assuming you supply the extension piece

Cheers,
Paul

Hi Paul. £33 sent via paypal f&f with details in the notes. PM me your address as I have an extension piece sat on my desk ready for the treatment. Time not a concern as this is not currently part of a working car.

Cheers

Trevor
 
Hi nod
Does this mean you have a spare egr valve that you are not going to use ?
If so would you consider selling it to me
I offer a machining service for the egr and would like to have one so I can offer on an exchange basis

cheers. Paul
 
28mm 3D printed spacer with o-ring and steel pipe liner. (Wasn’t sure about the temp in this area) fitted and leaves about 5mm clearance to the Bosch tandem pump. 80mm long bolts are a little too long but ok
 

Attachments

  • 46D96556-524A-4D56-9083-1A1D26867351.jpeg
    46D96556-524A-4D56-9083-1A1D26867351.jpeg
    1 MB · Views: 260
Back
Top