Blue connector Instrument cluster

Welshboy

Member
Hi can someone please advise which two pins should be bridged to stop the brake pad wear light showing in the dash - is it 2 and 24 or 29 and 24 as per image.
 

Attachments

  • 2020-05-27-121849_1360x768_scrot.png
    2020-05-27-121849_1360x768_scrot.png
    42.6 KB · Views: 292
Not done this myself but I do remember the last post in this thread.


Andy
 
2 & 24

Done it myself the other week

Paul


Sent from my iPhone using Tapatalk
Plucked up courage to have a go today. Got the instrument cluster out . Have unclipped the blue connector. I cannot see how to bridge the 2 and 24 pins either male or female and connect it up again. Please can you enlighten me ? Did you solder a link on the pcb ? Thx Tony
 
Open the blue connector and bridge the pins at the wire side of the connector


Sent from my iPhone using Tapatalk
 
Well done. It’s actually easier to do at the blue connector than the loom in the engine bay and removes the risk of damaging the abs wires in the same loom

Paul


Sent from my iPhone using Tapatalk
 
Back
Top