I´m about to replace the clutch on my 1.4 petrol, and what I can see the alignment tool is different than on the diesel.
Anyone who knows if it is the same with petrol that the hole in engine side is 0.6mm larger than clutch spline? Or will it work fine with a uniform rod of some sort?
If so, is there anyone who knows the diameter of the tool? I was thinking about 3d printing my own toll if it is just a uniform rod.
Anyone who knows if it is the same with petrol that the hole in engine side is 0.6mm larger than clutch spline? Or will it work fine with a uniform rod of some sort?
If so, is there anyone who knows the diameter of the tool? I was thinking about 3d printing my own toll if it is just a uniform rod.