Error code P0107

GFE

New Member
Hi all,

I have an error on my Audi A2 1.6fsi (2003 / 114540 KM).

Have yout got an idea of the defaut origin ?

In advance, I'm sorry for my english, but you are the only forum that I know where there is many experts to exchange and progress to resolve the problem.

---------------------------------------------------------------
01 Electronique moteur

Description système: MED7.5.11 4628
Version du logiciel: 036906013F
Codage: 00051

Codes d'erreur:
P0107 - Pression de tubulure d'admission/pression d'air Signal trop faible
statique

Best Regards
 
  • Like
Reactions: JHB

audifan

A2OC Donor
Translated to English gives..

01 Engine electronics

System description: MED7.5.11 4628
Software Version: 036906013F
Coding: 00051

Error codes:
P0107 - Intake manifold pressure / air pressure Signal too low
static

Over to our FSI gurus
 

GFE

New Member
I check response on internet and I found a defaut around the MAP Sensor.

I order a new one to be sure that the motor runs well.

Can you confirm the position of this on my BAD motor ?

Is it possible to clean this sensor or I have to change it ?
 

Andrew

A2OC Donor
I check response on internet and I found a defaut around the MAP Sensor.

I order a new one to be sure that the motor runs well.

Can you confirm the position of this on my BAD motor ?

Is it possible to clean this sensor or I have to change it ?
Sorry I missed this yesterday and so busy today have little time.

I assume you have checked Ross-Tech thoughts on P0107 here..


As to the location of G71 these two diagrams will help.

image.png


image.png


Andy
 

GFE

New Member
Many thanks, I will try this weekend to change the captor. My wife says to me that she did not perceive a change in the motor behavior.
 

GFE

New Member
I have change the captor

The captor is behind the motor and it is difficult to access.

But I still have the default 😭
 

RAB

Technical Specialist 1.2 TDI
This might be useful:


RAB
 

Andrew

A2OC Donor
I have change the captor

The captor is behind the motor and it is difficult to access.

But I still have the default 😭
Hi,

By captor I assume you mean what we call a sensor/sender.

No cure and money spent on a G71 not a good outcome.

You ask about location of the F96, unless it has escaped my attention I suggest it is not present on the A2 BAD engine, unless anybody knows better.

Looking at Ross-Tech's possible causes of P0107 I notice air leaks. Check the integrity of the dipstick and oil filler cap (top of engine) seals as these are known to cause problems and further the rubber tube from the oil filler cap, paying particular attention where it may be rubbing on any other bit of hardware.

Andy
 

GFE

New Member
Hi

Excuse me, in fact I change the sensor G71. Il would give photos to complete and share to the community but the resolution is too high....

I will check as soon as possible your recommandation and come back to us.
 
Top