Lower suspension ball joint query

Cenick

Cenick

A2OC Donor
United-Kingdom
I have a set of cast arms to replace my pressed ones at the same time as the suspension is being overalled.
I want to replace the rubber boots on the ball joints as one is split and I may as do the other at the same time, any ideas what size these are I’ve had a sea h on the forum but turned up zilch so far!

I have a selection of sizes available....

2d8173b12d346aa3cdf6ab5ea5357113.jpg


f6e2f1e695e013f1559e7671ced2bda0.jpg


Cheers
 
Can you not simply measure the joint and select the closest size of boot?
I guess the 12 x 28 refers to the diameter of the taper x diameter of base.
 
Sorry I have looked and can not find a reference to ball joint covers either. Since you have the arm at hand - so to speak, would be easy enough to measure it then a bit of trial and error with your stock, you should be able to find the best fit. Then you can tell us which size is correct.

Edit Catnip64 you beat me to it.
 
I was hoping someone already knew as my “stock” has to be returned to my parts supplier and I didn’t want to open packs unnecessarily

Anyway I’ve found that 15mm x 30mm is the correct size.
 
You must log in or register to reply here.
Back
Top