Lupo 1.2 3L help with error codes 00263 and 01314

Aras

New Member
Hi, I have a problem with Lupo 1.2 3L. When i start driving after about 10-20 seconds, the oil light starts flashing. I scan error codes 00263 transmission implausible signal and 01314 engine control module no communication. When I start braking, robot shift from a higher gear to a lower gear, the light stops flashing and flashes again when car stops completely. Please help me ,where to look for problems
 
IMG_0972.jpg
 
You have a poor electrical connection somewhere. Check the connections to the ECU (under the windscreen) and the gear actuator wiring loom connector under the hydraulic unit. While you are there, check the GCU connections (next to the ECU).

RAB
 
You have a poor electrical connection somewhere. Check the connections to the ECU (under the windscreen) and the gear actuator wiring loom connector under the hydraulic unit. While you are there, check the GCU connections (next to the ECU).

RAB
Thank you,
 
When I turn off the engine and start again the light does not come on. Start flashes when driving the gear switches from 1 to 2. Sometimes abs light appears
Which light? Oil pressure light?

RAB
 
Which light? Oil pressure light?

RAB
Oil light . No error codes if just start the engine or raising the engine speed , i try change gears manualy (when the car is stationary) everything is ok , but when go driving with gear E or manual ,start flashing oil lamp all driving time except when the gear is lowered during braking. Sometimes the ABS light comes on while driving, but when i swich engine off and on again everything is fine again.
 
Oil light . No error codes if just start the engine or raising the engine speed , i try change gears manualy (when the car is stationary) everything is ok , but when go driving with gear E or manual ,start flashing oil lamp all driving time except when the gear is lowered during braking. Sometimes the ABS light comes on while driving, but when i swich engine off and on again everything is fine again.
It might be a consequence of a poor ECU connection but check the oil pressure with a gauge, just in case. While you are checking the connections under the windscreen, check the drains to the wheel arches either side; if they block, the first consequence is water flowing through the cabin filter on to the passenger side floor.

RAB
 
It might be a consequence of a poor ECU connection but check the oil pressure with a gauge, just in case. While you are checking the connections under the windscreen, check the drains to the wheel arches either side; if they block, the first consequence is water flowing through the cabin filter on to the passenger side floor.

RAB
I found when i braking ang gear changing from 3 to 2 oil lamp stop flaching until car completly stop, and flash again , it happens everytime when i do same proces
 
There's no link between changing gear, braking and an engine oil pressure warning. As above, check the oil pressure with a gauge and check the connections to the ECU.

RAB
 
Today i drive car , engine shut down itself , try start but engine not starting ,starter working perfect . I think its the end of engine. Maybye belt problem. No error codes ,
 
Back
Top