G
Guest 4123
Guest
If you have solar PV panels at home and are exporting excess power to the grid for little reward, here's a solution. Installed between the immersion heater and the isolation switch, the IBoost will direct any excess to your immersion heater. Any excess is detected by a sensor clamped to the live connection between the meter and the consumer unit.
This is the control unit. It must be located within 3m of the immersion heater (because the connection to the immersion heater is DC).
The two communicate by wireless. There is also a wireless display unit available - not essential but it tells you what's going on. The instructions tell you that it should be installed by a qualified electrician but if you can wire a plug, you can install this.
RAB
This is the control unit. It must be located within 3m of the immersion heater (because the connection to the immersion heater is DC).
The two communicate by wireless. There is also a wireless display unit available - not essential but it tells you what's going on. The instructions tell you that it should be installed by a qualified electrician but if you can wire a plug, you can install this.
RAB