Tubing of Wind Screen jet washers

audi Atwo

Past Member
Hi all I was cleaning my jet washers as the drivers side was blocked up and the rubber (turned more hard plastic) tubing snapped any advise as to what I can replace it with, I was looking around online and local stores but wanted to know the diameter of the tubing for replacement if any one knows?

Thanks
John
 
https://audi.7zap.com/en/rdw/audi+a2/a2/2004-248/9/955-955010/

from this, it appears that the pipework starts as a 10m length that you then cut down to individual segments of specific lengths for the various tracts under the bonnet depending on which one needs to be replaced.

1J0 955 751D corrugated pipe 6X0,75X10000MM

generic VW group stock item.

enter 1J0955751D as a search term on Ebay - costs 18-20 quid freepost in the UK (obviously you can buy one from the US with another £20 of postage but probably not best idea!)

Hope this helps - good luck with the repair!
 
so the pipe is 6mm Dia (I would assume bore diameter) the wall thickness is 0.75mm
Any plastic flexible pipe of these dimension will do the job.
If it is very tight then place the end in boiling water for a few seconds and it will soften up nicely to allow it to be pushed over the end fittings
 
Thanks guys for all the great info will get this sorted once it stops raining ☔

Many thanks
John
 
Back
Top