VAG-COM or code reader?

G

Gaff

Guest
Hi,

I'm looking for advice on whether a VW-specific fault code reader or VAG-COM software is best for reading/resetting fault codes and service messages on an A2.

Is buying a cable and using the shareware version of VAG-COM sufficient?

Thanks

GA
 
VAG COM (full version) is a very complex and involved piece of kit.

It can do everything that your dealer can (and more), but can be tricky to use for a beginner.

A simple reader can clear many things, dependant on model, but not as much as the full VAG interface.

A shareware version and cheap lead can read a few modules, but cannot recode or reset anything.
Cheers,

Mike
 
I would say the VAG com is complex as Skipton says, i personally went for the code reader as it will do as much and more then my technical knowledge will allow anyway. Hopefully you will never have much more than a need for diagnostic, fault code clearing and service light including longlife. All these can be done with a code diagnostic tool , even I can use one, thats how simple they are!
 
I too went for the cheap lead and shareware. I've been able to lookup all the modules I've ever needed and clear fault codes. Might be worth spending £20 and then upgrading to a full VAG-COM once you "out grow" it

Cheers

Jonathan
 
more specific Q:

What reader or software version will let me switch back on the passenger airbag that VW disabled at my request?

Thanks

GA
 
You must log in or register to reply here.
Back
Top