Yes, that would be appreciated .... At least I can see the oil appearing somewhere on the flat plastic strip! (so I know that I'm roughly in range)
David
I'm still hoping that an A2OC member can supply this information, please? What is required are two measurements :- the distance in mm's from the point where the the flexible insertion-wire enters the plastic tip, to the start of the criss-cross measurement-band and the same again, but to the end of that band. This information will allow me to file two lines into my, as now, plain white measuring strip.
It'll be fully usable, then! Oh, it is a diesel, by the way ....
David