tikki
Member
A few months ago I fitted a plug in chip by PSI to upgrade my 75 bhp 1.4 TDi to 90 bhp. Unlike plug in chips I've fitted to A4's and Fiat TDi's, this needed a 12 volt supply to make it work.
Even after using Skiptons ELSA Win manual, I couldn't find a 12 volt supply I could safely use in the engine compartment and couldn't see how to get a supply through the bulkhead. Was pleased to see Skiptons thoughts on another forum today...
don't want to be a complete kill-joy, but you'll be in for a tricky time if you try it - getting anything through an A2s bulkhead is nigh on impossible due to the relatively small number of electrical connection between the engine bay and the cockpit.....
At present, I've run a supply from the panel under the passenger footwell, through a floor gromet, underneath the car, and up into the engine compartment - hardly satisfactory
Anyone know an easy way to pick up a 12 volt supply in the engine compartment??
tikki
Must work on my signature
Even after using Skiptons ELSA Win manual, I couldn't find a 12 volt supply I could safely use in the engine compartment and couldn't see how to get a supply through the bulkhead. Was pleased to see Skiptons thoughts on another forum today...
don't want to be a complete kill-joy, but you'll be in for a tricky time if you try it - getting anything through an A2s bulkhead is nigh on impossible due to the relatively small number of electrical connection between the engine bay and the cockpit.....
At present, I've run a supply from the panel under the passenger footwell, through a floor gromet, underneath the car, and up into the engine compartment - hardly satisfactory
Anyone know an easy way to pick up a 12 volt supply in the engine compartment??
tikki
Must work on my signature