celsisone
Member
Doing both a straight AUB engine swop or BCB with AUB parts is not that hard to do.
You need an AUB engine from a Skoda Fabia not an polo of Lupo.
the Fabia unit have the starter motor on the front of the engine like the Audi A2, This means you can you the Audi A2 gearbox.
All the sensors are the same so you can use the standard Audi wiring loom.
You will only need to swop the plugs for the fuel injectors.
ECU from the Skoda will plug into the standard loom too. you will need the pin code for both the original ECU and the Skoda unit, you can then program with Vagcom.
If you are going to use the BCB 1.6 engine there are a couple of things to need to be a where of. the sumps are different and most be changed over. you can use both the original A2 unit or the Skoda AUB unit.
the BCB engine has an oil cooler which you don't need, so just remove and fit 1.4 unit.
You need an AUB engine from a Skoda Fabia not an polo of Lupo.
the Fabia unit have the starter motor on the front of the engine like the Audi A2, This means you can you the Audi A2 gearbox.
All the sensors are the same so you can use the standard Audi wiring loom.
You will only need to swop the plugs for the fuel injectors.
ECU from the Skoda will plug into the standard loom too. you will need the pin code for both the original ECU and the Skoda unit, you can then program with Vagcom.
If you are going to use the BCB 1.6 engine there are a couple of things to need to be a where of. the sumps are different and most be changed over. you can use both the original A2 unit or the Skoda AUB unit.
the BCB engine has an oil cooler which you don't need, so just remove and fit 1.4 unit.