Sadly I am losing the will today as could not for the life of me find the end of the bonnet pull.
I knew there was an issue with the release as declared by previous owner but as weather was half decent today I wanted to have a go at replacing it. I would usually look at my other A2 to see where the cable is routed but alas its with a family member at present!
Could some advise the route from release catch in engine bay to where it goes into the bulkhead in detail as I think the route of mine is wrong and where it appears in the footwell area. No sign of any cable about drivers pedals and the end has been disconnect from the pull handle / snapped. Granted I could just yank old one out and try and get new one through where the hole is left but its a pig to get to due to brake fluid reservoir. Online manuals not really any help.
If anyone has replaced theirs I would welcome any direction.
Cheers, Paul
I knew there was an issue with the release as declared by previous owner but as weather was half decent today I wanted to have a go at replacing it. I would usually look at my other A2 to see where the cable is routed but alas its with a family member at present!
Could some advise the route from release catch in engine bay to where it goes into the bulkhead in detail as I think the route of mine is wrong and where it appears in the footwell area. No sign of any cable about drivers pedals and the end has been disconnect from the pull handle / snapped. Granted I could just yank old one out and try and get new one through where the hole is left but its a pig to get to due to brake fluid reservoir. Online manuals not really any help.
If anyone has replaced theirs I would welcome any direction.
Cheers, Paul