Clutch master cylinder internal leak?

[Xiter]

What do you think about this?
Clutch master cylinder internal leak or something else?

Clutch at the floor, engage any gear, release clutch to about 1-2 cm from the floor and the car wants to move forward but hasn't got enough drive to actually make it unless I'm in the garage on a completely flat floor. Then I can get it rolling very slowly. Release the clutch further and the normal bite point is reached.

If I then press the clutch to the floor again and release it, the first vague bite point may be gone but usually, it is still there.

 

[spike]

If the master cylinder was faulty I'd expect the clutch would not fully disengage and it would be difficult / noisy to put into gear.
Sounds like a similar problem to this - http://www.a2oc.net/forum/showthread.php?t=11048&highlight=clutch

Cheers Spike

 

[Xiter]

Thanks Spike, but I don't think it can be the same as Ruben's car. The clutch doesn't stick. The problem is that it sometimes got two bite points. If I try to estimate, the first one near the floor gives about 1% power, maybe less since I can't get the car to move unless it's absolutely flat. The other bite point at it's normal location is well, 100%.

My concern is that the bite point about 1-2 cm from the floor moves completely to the floor so I won't be able disengage the clutch 100%.