depronman
A2OC Donor
It has been brought to my attention by a member that these clear/translucent dipstick ends are not fit for purpose
It Would appear that a plastic which should have been superior to the ABS which I have been using for several years is not. It appears to be letting the oil into the layers of the printed part and swelling the plastic
Please don’t use any of these clear/ translucent ends, I will replace them FOC for abs ones if you let me know that you have the clear ones
I am away on holiday until the 15th Nov so I cannot do anything until then
If you have fitted one then please try to carefully pull out the dipstick rotating the handle once it has been pulled out a little may help
If you can get the dip stick out then remove the end if there is any signs of swelling
Apologies for any inconvenience caused
Paul
Sent from my iPhone using Tapatalk
It Would appear that a plastic which should have been superior to the ABS which I have been using for several years is not. It appears to be letting the oil into the layers of the printed part and swelling the plastic
Please don’t use any of these clear/ translucent ends, I will replace them FOC for abs ones if you let me know that you have the clear ones
I am away on holiday until the 15th Nov so I cannot do anything until then
If you have fitted one then please try to carefully pull out the dipstick rotating the handle once it has been pulled out a little may help
If you can get the dip stick out then remove the end if there is any signs of swelling
Apologies for any inconvenience caused
Paul
Sent from my iPhone using Tapatalk