carbore
Member
Hi,
My heat sheild is flapping around. I had a quick look at the MOT and its a combination of ripped shield and rusted fixings.
Whats the best way to attack the fixings, im assuming they are into the petrol tank so not a lot of room for alternate locations (drilling would be scary). Hopefully ill be able to get my good mole grips on them and wind them out, but im assuming some will snap flush to the plastic.
Any advice and tips appreciated.
Thanks.
My heat sheild is flapping around. I had a quick look at the MOT and its a combination of ripped shield and rusted fixings.
Whats the best way to attack the fixings, im assuming they are into the petrol tank so not a lot of room for alternate locations (drilling would be scary). Hopefully ill be able to get my good mole grips on them and wind them out, but im assuming some will snap flush to the plastic.
Any advice and tips appreciated.
Thanks.