G200 and G202 sensor signals

And was able to get it open and connectors are looking very good and not any water traces anywhere . Took them al out and checkt them on both sides and cleaned them with a contact spray for electronics . Also cleaned the ABS plug under the hood with the spray and was also looking very clean before already . Car has been without the battery also to reset maybe . But keep these two faults I could erase with my OBD scanner from Vident . But the keep coming back and also the abs and steering wheel lamp in my dashboard and when driving the beeps and warning brake light . Do I get the G200 be reported in the system with vag-com to get rid off this ? These are returning faults in my car now .
 

Attachments

  • 2023_05_22_13_56_IMG_7111.JPG
    2023_05_22_13_56_IMG_7111.JPG
    1.9 MB · Views: 68
I think the only thing you can do, is to replace the G200. We don't know enough to even consider the later type.
If you had a licensed copy of VCDS Lite, you could actually see the sensor reading, in degrees. With the car on level ground it should read zero degrees. It is possible that the sensor has moved, or drifted, and could be corrected using Basic Settings in VCDS.
Although the sensor is, probably, faulty, that check would confirm it. When you fit the replacement, it should be set up, with the car on level ground, to set it to zero, again with VCDS.
Mac.
 
The G200 is replaced by a new arrived one from Autodoc so it's needs to be corrected . I just installed VCDS Lite on my laptop and the post just brought me the usb cable to connected is to VAG cars as told in the ad by bol.nl . So trying later today if I can get into the system off my Audi .
The black foam that was around it on the console is not put in yet but I don't think any link with that ?
 

Attachments

  • 2023_05_23_10_39_IMG_7114.JPG
    2023_05_23_10_39_IMG_7114.JPG
    1.1 MB · Views: 57
gerspss said:
The G200 is replaced by a new arrived one from Autodoc so it's needs to be corrected . I just installed VCDS Lite on my laptop and the post just brought me the usb cable to connected is to VAG cars as told in the ad by bol.nl . So trying later today if I can get into the system off my Audi .
The black foam that was around it on the console is not put in yet but I don't think any link with that ?
Click to expand...
I believe you need the registered version ($99), of VCDS Lite to do Basic Settings. You may be able to see the block data, but I don't know.
Mac.
 
Thank to you both and going to give it a go later today :) But what happend to the old days with fixing your car with just a toolbox and two eyes and two ears and dirty hands :oops: and the car would listening without making his own decisions . Getting to old for this i think
 
I think that is posible the integration
Positive Voltage is 5 V and come from J104 (26)
GND is from J104 (24)
Signal G200 to J104 (6)
Signal G202 to J104 (40)
Put it in good position...
and try it!




1702001810468.png
 
Last edited:
You must log in or register to reply here.
Back
Top