G_Dobee
Member
Yes the original bumper went back on but does not sit close along the sides, this is a very common sight on the A2 as even a gentle nudge causes the side clips to either spring off or even break the edge of the bumper that fits on the side brackets. If the main crash bar behind the plastic bumper has been distorted at all then getting the bumper to fit properly will be difficult.
Thanks, that's good to know. I took a look earlier and there isn't any obvious damage just the one clip that doesn't look like it can go back. My phone battery is bad so it died before I could get photos. I think it was probably bumped on the right and the pressure popped the clip on the left out of place.
Luckily the water levels haven't gone up again since I siphoned it. I'm going to get it looked at when the numbers start to fall again as it's too risky right now.