Ami
A2OC Donor
you may find the twin pipe rotten as well as a result of diesel, just beneath the one in your picture, I had to change that as well ( hard to Find )Indeed Ami...looks horrid to do, but this one looks good.
you may find the twin pipe rotten as well as a result of diesel, just beneath the one in your picture, I had to change that as well ( hard to Find )Indeed Ami...looks horrid to do, but this one looks good.
Many thanks.. will get this also and change...Manifold O ring part number
037121688
I think you are looking for old stock. As far as I know Bosch pumps are NLA.May I ask where did you get the Bosch pump? Seems like they are NLA on a few sites. I am having issue with the brake servo, and inconsistent cold start crank time. 2004 BHC @155k, not sure if replacing the gasket will help. I understand Bosch pump is superior, anyone got part number for LUK pump?
If it needs a pump then buy a new one is often advice, don't recondition as they leak again quickly.
I had some issues with a Pierburg, and later managed to source a Bosch pump, see here: https://www.a2oc.net/community/index.php?threads/pierburg-vs-bosch.51931/May I ask where did you get the Bosch pump? Seems like they are NLA on a few sites. I am having issue with the brake servo, and inconsistent cold start crank time. 2004 BHC @155k, not sure if replacing the gasket will help. I understand Bosch pump is superior, anyone got part number for LUK pump?
Did younfollownthentorque settings and sequence? Don't have them fresh in my mind but something like 20nm top bolts and 10nm lower bolts, top first then bottom. Something like that, less than you would expect i recall thinkingHi all.
Any advise?.... I'll have another look tomorrow.
Did you clean the gasket recesses, clean the side of the head and fit new rubber gaskets? The small one is the important one.Ok
So i had a go at reusing the Luk pump as it looked like gasket failure attributingbto the leak.
The gaskets being two rubber gaskets.
Reassembled and it still looks lime a small weep.
Anything I have done wrong?
Many thanks
New quality seals.yep. super clean, all done as you say.
all I can think of to try is another set of rubber gaskets?
Many thanks again.Many thanks, will do just that now..